jschoeni
(Jschoeni)
#1
Hej!
I think I its a strange behavior:
I connect several track’s output to the master-bus-input (works of course
fine)
then a I save the session and close Ardour.
when I startup up ardour next time all the connections done before to
masterbus-in are lost, so I have to redo them again. (work)
is this like it should be?
aren’t the connections saved?
thanks
Juergen
sampo
(V2)
#2
Could you run this for us?
- Create a new session with a master bus
- Create a new track and make sure its’ outputs are connected to the Master bus
- Save & Quit
- Take a copy of the sessions .ardour file
(located /dir/you/created/it/in/[SessionName]/[SessionName].ardour)
- Open ardour and the session and verify that the connections are infact
lost also in this case
- Send the copy taken in (4) to us, either on the forums under this topic,
or to the ardour-users mailing list.
btw. Which version of ardour are you using?
Thanks.
jschoeni
(Jschoeni)
#3
Hej!
I’m using version 0.99.3
I did like you asked for, but this works fine.
so maybe it was just a mistake that I did.
If it should happen again, I will send you the
[SessionName]/[SessionName].ardour file
thanks for your help, hope I did not waste your time.
have a nice day
btw: whats the difference between this forum and the ardour-users mailing list?
Jürgen
taybin
(Taybin)
#4
The mailing list promotes more in-depth discussion of Ardour issues.