what now

Installation & Configuration Linux
#1

I have just spent almost five hour watching the compiling of ardour. Where did it get me? To a screen that says ,“scons: done building targets.”

Thats it. I type in ardour, and I get the following:
“bash: ardour: command not found”

So, apparently, ardour is stuck in limbo between finished and not finished. I am running Slackware 11 on a PII 450, 256 megs ram, 18 gigs SCSI hard disk space (barely even 1/4 full). I downloaded and installed (via compiling) every dependency listed. So, what’s the next step? If you need the entire list of what happened, I can get it from my console.

thanks
pappy

#2

Did you do
scons install
after building Ardour?

#3

Ardour 2.0 is launched using “ardour2” rather than “ardour”

#4

Just to emphasise what Philcora said, make sure you run scons install after you’ve finished building.

Have fun.